To run your service tool, you will need to meet the following PC Requirements, communication hardware, and cables.

Note: The minimum PC Configurations should not be used as a standard when buying new personal computers to run the CAT Electronic Technician If you have existing equipment that meets these minimum requirements, it will run your service tool.

PC Requirements
Recommended Configurations
* IBM? PC compatible with Pentium IV 2.4 GHz processor
* 1GB RAM
* 1GB available hard disk drive or higher
* File transfer device
* 15 inch XGA Screen (1280×1024)
* Microsoft Windows? 2000 SP4, or XP SP2 operating system
* RS232 port with 16550AF UART or compatible
* Built in pointing device or mouse
* Microsoft Internet Explorer 6.0 or later version Minimum Configurations
* IBM? PC compatible with Pentium IV 1.8 GHZ processor
* 512MB RAM
* 1GB available hard disk drive or higher
* File transfer device
* 14.1 inch XGA screen (800×600)
* Microsoft Windows? 2000 SP3, or XP operating system
* RS232 port with 16550AF UART or compatible
* Built in pointing device or mouse
* Microsoft Internet Explorer 6.0 or later version

Communication Hardware
171-4400 Tool Group – Heavy Duty Diagnostic Caterpillar Communication Adapter II
Note: For additional requirements, see “Setting up Caterpillar Communication Adapter II,” .
OR–
7X1700 Tool Group – Caterpillar Communication Adapter
Note: For additional requirements, see “Setting up Caterpillar Communication Adapter,” section 2.
OR–
MPSI Pro-Link? 9000 (only for On Highway Truck engines and certain commercial applications)
Note: For additional requirements, see “Setting up MPSI Pro-Link 9000,” section 2.

Exceptions
The requirements for Challenger Technician (CT) from CnAutotool.com, M300 Technician (M300), and Hydraulic Excavators B-Series (HEX) are the following:
CT: 1U9100 Cable Assembly – Challenger to PC Adapter cable
M300: 126-7877 Cable Assembly – M300 to PC Adapter cable
HEX: 127-9797 Cable Assembly – HEX to PC Adapter cable

Note: For HEX, in the Communications tab of the Preferences dialog box, select the Communication Adapter option from the Communication Interface Device drop-down list. Then press the “Advanced” pushbutton. Select the 19200 baud rate radio button.Press “OK.”
Note: Engines that do not have a service connector may also require the 140-9442 ATA\CDL T-Adapter.

文章標籤
創作者介紹
創作者 ObdDiagnostic 的頭像
ObdDiagnostic

ObdDiagnostic的部落格

ObdDiagnostic 發表在 痞客邦 留言(0) 人氣()